Twinax Interface Menu - IBM 6400i Setup Manual

Twinax Interface Menu

Twinax
(4)
Interface
(from page 104)
Print Print Character
(3)
Language Table
See the following
page.
Early Print
Cancel
Complete
Buffers
Disable*
Enable*
Enable
Disable
LAC Print Text
Approximation Direction
On* Control By Host*
Left to Right
Off
Right to Left
To view options, press:
Scroll Scroll Enter
To select an option, press:
To exit the configuration menus
and return to READY, press:
* = Factory Default
Active Print
Language
Standard Print Language* 4234-2*
Alternate Print Language 5225
4234-12
Hex
Transparent
(2)
Control
Lead-In Characters
Set 1 <%>*
Set 2 ¬¬$
Set 3 _%_
User Defined
User Defined Codes
Start Code 1
Start Code 2
Stop Code
Alternate Set 80-9F
Printable*
Control Code
Override Format
Host Control
Disable* Disable*
Enable Enable
NOTE:
Return
(1)
If the IPDS feature is installed, the 4234-12 option is the
default, and will appear in this menu. If IPDS is not installed, the
Enter
4234-12 option will not appear in this menu, and 4234-2
becomes the default.
(2)
If the IPDS feature is installed, the EARLY PRINT
COMPLETE option appears in this menu.
Start
(3)
Does not apply to IPDS.
(4)
The Twinax and Coax interface menus only appear in the
menus if the IBM Coax/Twinax is installed.
(5)
Only if Autoswitching is enabled.
Printer Printer
Emulation Address
Address 1*
Address 2
(1)
Address 3
Address 4
Address 5
Address 6
Address 0
Undefined Undefined
Character Character
Reporting Substitution
Enable* 60*
Disable 40 - FE (HEX)
Maximum
Printable Width
13.2 inches* Disable*
Enable
13.6 inches
Twinax Interface Menu
World
Trade
Standard Character Set*
Extended Character Set
Load Alternate
Character
Option
Enable*
Disable
Hex Print C/T
(3) (5)
Hotport
Mode
Port Type
Disable*
Twinax
Coax
Timeout
15 Sec*
10 Sec - 180 Sec
Report Status
Disable*
Enable
117