Ethernet Menu
Item
AUTO*
NW FRAME
ETH II
802.2
802.3
SNAP
ON*
NETBIOS
OFF
ON*
APPLETALK
OFF
Coax SCS Menu
Use the Coax SCS Menu to define how the printer handles SCS data over the
coax attachment. The following table describes the settings you can change
from the Coax SCS Menu. An asterisk (*) next to a value in the table indicates
the factory default. The Coax SCS Menu appears only if you have the coax
network interface card installed.
Notes:
1. To select a new value, press the Enter key when the value is displayed in
the message display area. An asterisk (*) appears next to the value in the
message display area, indicating that it is now active.
2. Values set in print jobs override Coax SCS Menu values set at the printer.
3. For more information about configuring the coax attachment, see IBM
Network Printers: Twinax/Coax Configuration Guide.
4. If you are unfamiliar with using the operator panel to work with menus,
please read "Using the Operator Panel Keys" on page 23 and "Navigating
Menus" on page 24 before continuing.
116
InfoPrint 20: User's Guide -- CD Version
Value
Selects the Netware frame type.
v AUTO—the printer uses the frame type of the first frame
it receives.
v ETHER II—the printer uses the Ethernet Standard Version
2 frame type.
v 802.2—the printer uses the IEEE 802.2 protocol.
v 802.3—the printer uses the IEEE 802.3 protocol.
v SNAP—the printer uses the SNAP protocol.
Note: This menu item appears only when NETWARE is
ON.
Turns NetBIOS communications on or off.
v ON—enables NetBIOS communications.
v OFF—disables NetBIOS communications.
Turns AppleTalk communications on or off.
v ON—enables AppleTalk communications.
v OFF—disables AppleTalk communications.
Description