Table of Contents
Advertisement
v To determine the minimum bottom margin, subtract the length of the
v For the top margin, use whatever value you would normally use. No
3. If you are printing from an IPDS application:
a. Use the Custom Forms Menu to define the custom form size. You can
b. Use the IPDS Menu to set the Custom Form item to the custom form
See "Defining Custom Form Sizes for IPDS" on page 66 for more
|
information.
|
4. Load paper top-edge first and print side up.
5. Load envelopes with the flap-side down.
6. Always run some test prints before submitting a large job.
a. Subtract the custom form width from 330 mm (330 mm - 230 mm =
100 mm)
b. Divide the result by 2 (100 mm / 2 = 50 mm)
Your application would then apply at least a 50 mm right and left
margin. Note that the minimum margin prints to the edge of the paper.
If, for example, you want to leave a margin of 10 mm on each side, add
the 10 mm to the minimum.
custom form from 508 mm or 20 in. For example, if your custom form is
300 mm long, subtract the custom form length from 508 mm (508 mm -
300 mm = 208 mm).
Your application would then apply at least a 208 mm bottom margin.
Again, note that the minimum margin prints to the edge of the paper. If
you want to leave additional space at the bottom of the page, add it to
the minimum.
special calculations are required.
define up to five custom form sizes.
you want to use.
Chapter 4. Paper Handling
55
Advertisement
Table of Contents
