Token Ring Menu - IBM InfoPrint 20 User Manual

IPDS Menu Item
OFF*
| EARLY COMPL
ON
|
|
|
|
|
|
|
|
|
|
|
|
COAX*
IPDS PORT
TX
ETHER
TRING
1*
CUSTOM FORM
2
3
4
5

Token Ring Menu

Important!
For information about configuring the token-ring attachment, please see
IBM Network Printers: Ethernet and Token Ring Quick Configuration Guide,
which comes with the token-ring network interface card. "Chapter 9.
Configuring Printer Network Addresses" on page 185 describes how to
define the IP address, default gateway address, and subnet mask from
the operator panel.
Use the Token Ring Menu to configure the token-ring attachment. The
following table describes the settings you can change from the Token Ring
Menu. An asterisk (*) next to a value in the table indicates the factory default.
The Token Ring Menu appears only if you have the token-ring attachment
installed.
110
InfoPrint 20: User's Guide -- CD Version
Value
Turns early print completion on or off for IPDS data sent
over the twinax attachment. To turn early completion on or
off for non-IPDS data over the coax attachment, use the
EARLY COMPL item on the Coax Setup Menu. EARLY
COMPL displays on the IPDS Menu only when the twinax
network card is installed.
v OFF—the printer waits until the job is physically
complete to signal the host that the job is complete.
v ON—the printer signals the host that the job is complete
as soon as the IPDS data is formatted.
Setting EARLY COMPL=ON may improve print
performance, but may also degrade recovery and cause lost
data from some printing problems, such as jams.
Specifies the attachment you use for IPDS jobs.
Note: You can print IPDS from more than one port; setting
this item, therefore, does not restrict you from printing from
multiple ports.
Specifies the custom form to use. The Custom Forms Menu
lets you specify up to five custom forms. See "Defining
Custom Form Sizes for IPDS" on page 66 for information on
defining custom forms.
Description