Boot Diagnostics Menu - IBM 6400 Maintenance Information Manual

Step Press
8.
Stop
Start
-OR-

Boot Diagnostics Menu

Printer boot-up software contains a menu structure that you can access by
holding down the Eject/Restore and Stop keys while powering up the printer.
These menus are not intended for the end user, but provide useful information
for manufacturing and maintenance personnel. The boot diagnostic menu
structure is depicted in Figure 19.
Activating The Boot Diagnostic Menu
1. Set the printer power switch to O (off).
2. Press and hold down the Eject/Restore and Stop keys.
3. While holding the Eject/Restore and Stop keys, set the printer power
switch to 1 (on).
4. When "BOOT DIAGNOSTICS / PRESS ENTER" appears on the LCD,
release the Eject/Restore and Stop keys.
5. Press the Enter key. Menu options are shown in Figure 19.
Exiting The Boot Diagnostic Menu
Method 1: Reset the printer from the Menu
1. Using the directional keys, move to the MISC UTILITIES / RESET
PRINTER menu option. (See menu map on page 138.)
2. Press the ENTER key.
Method 2: Cycle power
1. Power off the printer.
2. Wait 15 seconds.
3. Power on the printer.
Boot Diagnostics Menu
Displayed Result
NOT READY Stop halts the test, exits
the menu, and puts the
printer in the NOT
READY state. Start halts
the test, exits the menu,
and puts the printer in the
READY state.
Notes
137