Token Ring Tcp/Ip Attachment Information; Token Ring Tcp/Ip Attachment Items - IBM INFO PRINT 3000 Operator's Manual

Token Ring TCP/IP Attachment Information

Table 19 lists all configuration items, what each item is used for, and the allowable
value options for each item. The factory-set default values are underlined.
Table 19. Token Ring TCP/IP Attachment Items
Configuration Item Description
Token Ring TCP/IP Specifies if the Token Ring adapter is installed.
Installed
TCP Port Specifies the TCP socket address of the attachment.
Notes:
1. Only one address is required for operating a simplex
2. If your installation runs in dual simplex and duplex
3. The TCP Port numbers specified in the printer
4. Because Printer 1 in a dual simplex system and the
IP Address Specifies the Internet protocol (IP) address of the printer
in dotted decimal format. Get this value from your LAN
administrator. This value must match the IP address
value in the host PSF configuration.
This value is unique to a duplex system, and is the same
regardless of whether the printer is in duplex or
dual-simplex mode.
Subnet Mask Specifies the mask that identifies the local subnet in
dotted decimal format. Get this value from your LAN
administrator. If you do not have a local subnet, leave
this field blank.
Default Gateway Specifies the IP address of the default gateway in dotted
Address decimal format. Get this value from your LAN
administrator.
MTU Size Specifies the Maximum Transmission Unit (MTU) –
maximum allowable length of IP packets.
Hardware address Specifies the TCP/IP Token Ring adapter ROM address.
system.
mode, specify the same TCP Port value for duplex
mode as you do for Printer 1 in dual simplex mode.
(IBM recommends using the default value of 5001.)
Also, make sure you specify a unique value for
Printer 2 in simplex mode; Printer 1 and Printer 2
cannot use the same value. (If you use the default
value of 5001, for Printer 1, IBM recommends using
5002 as the value for Printer 2.)
configuration must match the PORT numbers
assigned in the host PSF system.
complete system in duplex system share a common
port number, operational procedures must be defined
to distinguish between duplex and dual simplex
printing. The easiest way to manage this is to assign
separate queues for duplex versus dual simplex
output (for PSF/2 and PSF/6000), and to assign at
least a unique job class for duplex jobs (for S/390 host
PSF systems).
Value Options
Yes or No
5001 to 65536.
X.X.X.X where X 255.
X.X.X.X where X 255
X.X.X.X where X 255
60 to 4096
This address cannot be changed.
Chapter 8. Configuring the System
235