Chin Fairing - Buell 2007 ULYSSES Service Manual

HOME

CHIN FAIRING

REMOVAL
1. Turn wheel full right or left for easier access to center fas-
teners.
2. See Figure 2-124. Remove center section fasteners and
washers (2).
3. Remove left section fasteners and washers (4).
4. Remove right section fasteners and washers (6).
5. Remove chin fairing.
NOTE
To separate the left, right and center sections, drill out the riv-
ets.
INSTALLATION
NOTE
To join the left, right and center sections, use the rivet gun
from a Marson Thread-Setter
MAR39200HD.
1. Apply LOCTITE 271 (red) on all fasteners.
2. See Figure 2-124. Position the assembled chin fairing (5)
and loosely install right side fasteners and washers (6).
3. Align center section (1) and loosely install center section
fasteners and washers (2).
NOTE
Turn wheel full right or left for easier access to center fasten-
ers.
4. Align left section (3) and loosely install left side fasteners
and washers (4).
5. Tighten all fasteners to 36-48 in-lbs (4-5 Nm).
2-90 2007 Buell Ulysses: Chassis
TM
Tool Kit MODEL NO.
b0942x2x
5
6
1. Center section
2. Center section fasteners and washers (2)
3. Left section
4. Left section fastener and washer (2)
5. Right section
6. Right section fastener and washer (2)
Figure 2-124. Chin Fairing
2.38
4
3
1
2