Buell 2007 ULYSSES Service Manual page 633

HOME
11966b
8
7
1. Main harness
2. Battery ground cable
3. Battery positive cable
4. ECM connectors [10] [11] and [164]
NOTE
Rear turn signal, tail lamp and license plate lamp connectors
are inside the license plate bracket.
9. Remove fuse block and relay center from support
bracket.
10. See Figure 7-83. Remove the wire cover to access and
disconnect:
Wire harness ground fasteners in left tail section.
Rear brake light switch connector [121].
ECM connectors [10], [11] and [164].
BAS (bank angle sensor) connector [134].
Right rear turn signal connector [18].
Left rear turn signal connector [19].
License plate lamp connector [45].
Tail light connectors [93].
Rear auxiliary power outlet [180].
Interactive exhaust connector [165B], (under main
wiring harness)
7-70 2007 Buell Ulysses: Electrical
2
5
Figure 7-83. Main Harness and Electrical Connectors Under Seat
4
5. Fuse block and relay center
6. BAS (bank angle sensor) connector [134]
7. Rear auxiliary outlet [180]
8. Center tail section
11. Loosen seat latch bracket fasteners and remove harness
from under the seat latch bracket.
12. Remove main harness and grommet from battery tray.
13. Remove the rear shock absorber assembly and reser-
voir. See 2.23 REAR SHOCK
14. Remove fan. See 4.38 COOLING
1
6
ABSORBER.
FAN.