Buell 2007 ULYSSES Service Manual page 520

HOME
6250
9
8
7
1. Tool handle
2. Washer
3. Bearing
4. Bridge
5. Forcing screw
6. Diaphragm spring
7. Snap ring
8. Pressure plate
9. Spring seat
Figure 6-22. Pressure Plate Assembly
8815
3
1. Adjusting screw assembly
2. Retaining ring
3. Tab recesses
Figure 6-23. Clutch Adjusting Screw Assembly and
Retaining Ring
7. Install primary cover. See
8. Adjust Clutch. See
1
9. Fill with GENUINE HARLEY-DAVIDSON FORMULA+
2
TRANSMISSION AND PRIMARY CHAINCASE LUBRI-
CANT (Part No. 99851-05). See
3
4
Connect positive (+) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
5
sion, which could result in death or serious injury.
(00068a)
6
10. Connect negative battery cable to battery terminal.
Tighten fastener to 72-96 in-lbs (6.8-10.9 Nm).
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
11. Install seat. See
2
1
6.2 PRIMARY
1.8 CLUTCH.
1.8
11 1
WARNING WARNING
11 1
WARNING WARNING
2.45 SEAT.
2007 Buell Ulysses: Drive/Transmission
COVER.
CLUTCH.
6-15