Buell 2007 ULYSSES Service Manual page 461

HOME
Fuel Screen Replacement
1. Remove fuel pump assembly from tank. See REMOVAL
in this section.
2. See Figure 4-89. Disconnect electrical connectors (5, 6).
3. Remove ground fastener (12) from the fuel pump and
fuel filter bracket (9).
4. Remove fuel pressure regulator E-clip (7).
5. Pull regulator housing (3) and fuel pump (8) with bracket
(9) as an assembly.
6. See Figure 4-90. Pry fuel screen (1) from fuel pump (2).
7. Install new fuel screen on fuel pump.
8. Install regulator housing assembly (4, 5) and fuel pump
(2).
9. Install E-clip (8) in bottom groove on shaft.
10. See Figure 4-89. Install ground fastener (12) and con-
nect ground wires to bracket (9) and tighten to 18-22 in-
lbs (2.0-2.5 Nm).
11. Connect fuel pump connectors (5, 6).
b1173x4x
1. Fuel screen
2. Fuel pump
3. Low fuel level sensor
4. Fuel pressure regulator housing
5. Fuel pressure regulator
4-112 2007 Buell Ulysses: Fuel System
10
9
8
Figure 4-90. Fuel Pump Assembly
Fuel pump connectors are two different sizes to prevent incor-
rect installation.
12. Route overflow hose (10) through guide in bracket (9).
13. Install fuel pump assembly. See INSTALLATION in this
section.
Table 4-38. Fuel Pump
Specifications
SPECIFICATION
Pressure Setting
Operating Voltage
Fuel Delivery
Current Draw
7
2
1
6. Plastic retaining ring, pressure regulator
7. Fuel filter
8. E-clip
9. Connectors, fuel pump
10. Fuel pump wiring harness
NOTE
DATA
49 PSI
13.2 volts
60 LPH @ 45 PSI [310 kPa]
6.0 amps
6
4
5
3