Headlights And Support Bracket - Buell 2007 ULYSSES Service Manual

HOME

HEADLIGHTS AND SUPPORT BRACKET

REMOVAL
1. Remove seat. See 2.45
11 1
WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a)
2. Disconnect negative (–) cable (black) from battery. See
1.4 BATTERY MAINTENANCE.
3. Remove windshield and windscreen. See
SHIELD AND WINDSCREEN.
4. See Figure 2-107. Disconnect horn connectors [122] (2).
11930a
10
6
1. Horn
2. Horn connectors [122]
3. Horn bracket
4. Horn fastener
5. Headlight connector [38]
2-74 2007 Buell Ulysses: Chassis
SEAT.
WARNING
2.44 WIND-
1
8
7
Figure 2-107. Headlight and Support Bracket
Horn (1) can remain attached to support bracket. The horn
can be removed and replaced as needed.
5. See Figure 2-107.
6. Remove female connector [38B] from support bracket (9)
by sliding connector up and off of bracket clip.
7. Remove both upper headlight fasteners (6).
Access the headlight fasteners with a socket extension
through the openings in the sides of the front modules.
8. Remove headlight alignment fastener from underside of
front fender and remove headlights.
9. Remove two fasteners (8) from in the left and right mod-
ules and remove support bracket.
4
3
2
8
7
6. Screws (2), upper headlight mounting
7. Headlight assembly
8. Screws (2), headlight support bracket
9. Headlight support bracket
10. Left and right front modules
NOTE
Separate headlight connector [38] (5).
NOTE
5
9
6
2.28
10