Buell 2007 ULYSSES Service Manual page 272

HOME
b0986x3c
7
8
1. Clamp, Torca
2. Muffler
3. Muffler strap, front
4. Front muffler strap fastener
5. Front muffler mount
6. Rear muffler bracket
7. Rear muffler strap fastener
8. Muffler strap, rear (2)
19. See Figure 3-44. Apply LOCTITE 271 (red) to rear muf-
fler bracket fasteners, install and tighten to 32-36 ft-lbs
(43.4-48.8 Nm).
20. Install front muffler mount and leave loose at this time.
NOTES
DO NOT install muffler at this time. It is necessary to
install muffler mounts first in order to properly install feed
oil line.
At this point it will be necessary to install the oil lines. It is
important to follow this procedure to ensure correct ori-
entation of oil lines in order to establish the proper clear-
ances needed between the oil lines and varied
components on the vehicle.
2
Figure 3-44. Muffler and Mounting System
6
1
If any oil line fittings are found to be loose, or not oriented
in the proper position, those fittings must be removed
and thoroughly cleaned. After cleaning, apply LOCTITE
565 Sealant to the fitting and re-install to the correct ori-
entation. When tightening oil lines, always support the oil
line fitting with a wrench to maintain proper orientation
and prevent damage to the oil line fitting.
2007 Buell Ulysses: Engine
5
4
3
3-33