Trouble Code 36 - Buell 2007 ULYSSES Service Manual

HOME

TROUBLE CODE 36

GENERAL
Cooling Fan High Voltage
This code occurs when the engine is running and the ECM
has commanded the fan on, and the voltage remains high at
pin 6 of ECM connector [11] (gray connector).
NOTE
An engine temperature (ET) sensor signal, indicating a cylin-
der head temperature above 428° F (220° C), causes the
ECM to command the fan on. When ignition is OFF, fan may
run for approximately two and a half minutes depending on
temperature of vehicle when ignition was turned off. See
Table 4-29. Cooling Fan Specifications.
Table 4-29. Cooling Fan Specifications
FAN ON
Key ON 220° C (428° F)
Key OFF 170° C (338° F)
This code can also set if fan blade does not spin (blocked fan
blade) when fan is commanded on and battery voltage is
applied to fan.
Cooling Fan Low Voltage
This code will set when the ignition key is ON and the ECM
does not sense voltage at pin 6 of ECM terminal 11 (gray
connector).
DIAGNOSTICS
Diagnostic Notes
The reference numbers below correlate with the circled num-
bers on the Code 36 flow charts.
1. Use HARNESS CONNECTOR TEST KIT (Part No. HD-
41404), gray pin probes and patch cord.
2. Connect BREAKOUT BOX (Part No. HD-42682) to ECM.
See 4.6 BREAKOUT BOX.
4-80 2007 Buell Ulysses: Fuel System
8898
FAN OFF
180° C (356° F)
150° C (302° F)
Figure 4-55. Cooling Fan
4.26