Wheels - Buell 2007 ULYSSES Service Manual

HOME

WHEELS

GENERAL
Good handling and maximum tire mileage are directly related
to the care of wheels and tires. Regularly inspect wheels and
tires for damage and wear. If handling problems occur, see
1.21 TROUBLESHOOTING
See 1.7 TIRES AND WHEELS
inflated to the recommended air pressure. Always balance
the wheel after replacing a tire.
11 1
WARNING
Do not inflate tire beyond maximum pressure as speci-
fied on sidewall. Over inflated tires can blow out, which
could result in death or serious injury. (00027a)
TROUBLESHOOTING
See Figure 2-3. Check tire inflation pressure at least once
each week. At the same time, inspect tire tread for punctures,
cuts, breaks and other damage. Repeat the inspection before
long trips.
CHECK FOR
Loose axles.
Excessive side-play or radial (up-and-down)
play in wheel hubs.
Rims and tires out-of-true sideways; should
not be more than 0.080 in. (2.03 mm).
Rims and tires out-of-round or eccentric
with hub; should not be more than 0.090 in.
(2.29 mm).
Irregular or peaked front tire wear.
Correct tire inflation.
Correct tire and wheel balance.
Steering head bearings.
Damper tubes.
Shock absorbers.
Swingarm bearings.
2-8 2007 Buell Ulysses: Chassis
or Table 2-9.
for tire pressures. Keep tires
WARNING
Table 2-9. Wheel Service
Tighten front axle. See
Tighten rear axle. See
Replace wheel bearings.
Replace rims. See
Replace rims. See
Replace as described under
TIRES and
Inflate tires to correct pressure. See
Static balance may be satisfactory if dynamic balancing facilities are not
available. However, dynamic balancing is strongly recommended.
Check for proper torque and replace worn or damaged bearings. See
STEERING HEAD
Check for leaks. See
Check damping action and mounts. See
ADJUSTMENTS.
Check for proper torque and replace worn or damaged bearings.
See 2.19 SWINGARM AND
b0195x2x
Figure 2-3. Checking Tire Inflation Pressure
REMEDY
2.5 FRONT WHEEL.
2.6 REAR WHEEL.
2.7 CHECKING CAST RIM
2.7 CHECKING CAST RIM
2.5 FRONT
2.7 CHECKING CAST RIM RUNOUT.
1.7 TIRES AND
BEARINGS.
2.16 FRONT FORK.
BRACE.
RUNOUT, and 2.8 TIRES.
RUNOUT, and 2.8 TIRES.
WHEEL, 2.6 REAR WHEEL,
WHEELS.
1.11 SUSPENSION DAMPING
2.4
2.8
1.12