Buell 2007 ULYSSES Service Manual page 148

HOME
ASSEMBLY
11 1
WARNING
Be sure that brake fluid or other lubricants do not con-
tact brake pads or discs. Such contact can adversely
affect braking ability, which could cause loss of control,
resulting in death or serious injury. (00290a)
10096
1. Rear wheel forcing screw
2. Front wheel forcing screw (Part No. 280856)
Figure 2-23. Forcing Screws Used for Front and Rear
Wheel Bearing Installation
NOTES
Press the rotor side bearing in first ensuring it is seated
on the shoulder of the wheel. Followed by pressing the
alternate side bearing until it contacts the spacer.
See Figure 2-23. When installing rear wheel bearings it
is necessary to use the FORCING SCREW (1) from the
STEERING HEAD BEARING RACE INSTALLER (Part
No. HD-39302).
The Wheel Bearing Remover and Installer (B-43993-50)
consists of the Front Wheel Bearing Remover Collet (B-
43993-7), Rear Wheel Bearing Remover Collet (B-
43993-8), Rear Wheel Bearing Installer (B-43993-9),
Front Wheel Bearing Installer (B-43993-10) and Backing
Plates (B-43993-11 front wheel) and (B-43993-12 rear
wheel).
The procedure for the rear wheel bearing installation is
the same as front wheel bearing installation. See
ing Installation in 2.5 FRONT
1. See Figure 2-22. Install wheel bearing (3) on rotor side of
motorcycle.
2. Install rear wheel spacer (4).
3. Install wheel bearing (3) on sprocket side of motorcycle.
4. Install sprocket.
a. Position sprocket (6) on wheel (5) keeping lip of
sprocket facing the inside.
b. Install new sprocket fasteners (7) and washers tight-
ening to 35-37 ft-lbs (48-50 Nm).
5. Install rear rotor (2).
a. Position rear brake rotor (2) on wheel (5).
b. Install brake rotor (2) with new rotor mounting fas-
teners (1) and tighten to 25-27 ft-lbs (34-37 Nm).
WARNING
1
2
Bear-
WHEEL.
INSTALLATION
1. Center rear wheel in the swingarm at the same time slid-
ing the drive belt onto the rear sprocket.
2. With wheel centered in swingarm, lower bike to align
swingarm and wheel hub.
3. Apply ANTI-SEIZE LUBRICANT to hole in right side of
swingarm where rear axle slides through.
b1036x2x
Figure 2-24. Anti-Seize Lubricant Location
4. See Figure 2-24. Coat the axle with ANTI-SEIZE LUBRI-
CANT.
5. Slide axle through right side of swing arm and wheel hub
and thread partially into swingarm on left side.
6. Install idler pulley. See 6.6 DRIVE BELT
2007 Buell Ulysses: Chassis
SYSTEM.
2-19