Breakout Box - Buell 2007 ULYSSES Service Manual

HOME

BREAKOUT BOX

GENERAL
The BREAKOUT BOX (Part No. HD-42682) splices into the
main harness. Used in conjunction with a DVOM, it allows cir-
cuit diagnosis of wiring harness and connections without hav-
ing to probe with sharp objects.
INSTALLATION
1. See 4.30 ELECTRONIC CONTROL
2. Depress latches on each side of connectors [10] (black)
and [11] (gray) and detach connectors from the ECM.
3. See Figure 4-9. Attach Breakout Box (1) to black connec-
tor [10].
a. Attach black connector from Breakout Box to corre-
sponding black ECM connector.
b. Attach black connector from the wiring harness to
black connector on Breakout Box.
4. Attach Breakout Box to gray connector [11].
a. Attach gray connector from Breakout Box to corre-
sponding gray ECM connector.
b. Attach gray connector from the wiring harness to
gray connector on Breakout Box.
REMOVAL
1. See Figure 4-9. Depress latches on each side of connec-
tors [10] (black) and [11] (gray).
2. Detach Breakout Box connectors from ECM connectors.
3. Detach Breakout Box connectors from wiring harness.
4. Reconnect harness to ECM. See
CONTROL MODULE.
4-10 2007 Buell Ulysses: Fuel System
MODULE.
1.
4.30 ELECTRONIC
2.
3.
4.
Figure 4-9. ECM and Breakout Box with Connections
1
2
4
Breakout box
Breakout box grey and black connections at main
harness
Breakout box grey and black connections at ECM
ECM
4.6
11990a
3