License Plate Lamp Assembly - Buell 2007 ULYSSES Service Manual

HOME

LICENSE PLATE LAMP ASSEMBLY

REMOVAL/DISASSEMBLY
1. Remove seat. See 2.45
2. See Figure 7-51. Remove the cover for the rear wiring
(3).
3. Disconnect the two connectors [45] from license plate
lamp harness.
4. Pull the lamp assembly away from license plate bracket
(1) pulling the harness out of the license plate bracket.
11995
1. Center tail section
2. License plate bracket
3. Cover, rear wiring
Figure 7-51. License Plate Lamp Mounting
ASSEMBLY/INSTALLATION
1. See Figure 7-52. Install new license plate lamp assem-
bly.
a. Insert license plate lamp wiring harness through
hole and route into the center tail section (2) and the
license plate bracket (4).
b. Attach the two connectors [45] from license plate
lamp to main harness.
7-48 2007 Buell Ulysses: Electrical
SEAT.
1
2
3
c. Attach lamp (3) and wire cover (5) to tail section
using washers and jam nuts (1) and tighten to 12-36
in-lbs (1.4-4.1 Nm).
d. See Figure 7-52. Attach front of wire cover by install-
ing remaining fasteners (6) and tightening to 36-48
in-lbs (4.1-5.4 Nm).
2. Check lamp for proper operation. If operation fails,
reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to ON.
b. Check for license plate lamp illumination.
c. Turn ignition key switch to OFF.
1 1
WARNING WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
3. Install seat. See 2.45 SEAT.
3
1. Jam nuts with washers (2)
2. Center tail section
3. License plate lamp
4. License plate bracket
5. Wire cover
6. Front wire cover fasteners
Figure 7-52. License Plate Lamp
7.14
b1201x7x
2
1
4
5
6