Main Wire Harness - Buell 2007 ULYSSES Service Manual

HOME

MAIN WIRE HARNESS

GENERAL
The main wire harness runs from the front of the motorcycle
to the tail section.
Always replace plastic tree fasteners when replacing main
wire harness. Remove tree fasteners carefully, do not leave
any of fastener in frame.
REMOVAL
NOTES
To ensure correct installation, make note of wire routing
and cable strap locations before removing main wire har-
ness.
Main wire harness is removed from rear of vehicle
through fan section of frame.
1. Remove seat. See 2.45
2. Remove air cleaner cover. See
ASSEMBLY.
3. Remove sprocket cover. See
1 1
WARNING WARNING
Disconnect negative (-) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00049a)
4. Unthread fastener and remove battery negative cable
(black) from battery negative (-) terminal.
5. Pull back terminal cover boot on battery positive cable
(red).
6. Unthread fastener and remove battery positive cable
from battery positive (+) terminal.
7. Remove battery.
SEAT.
4.44 AIR CLEANER
2.35 SPROCKET COVER.
12097a
1
1. Fastener with washer
2. Positive battery cable
Figure 7-82. Positive Battery Cable
(Protective Boot Not Shown)
8. See Figure 7-82. Disconnect positive battery cable from
starter.
2007 Buell Ulysses: Electrical
7.24
2
7-69