Buell 2007 ULYSSES Service Manual page 204

HOME
DISASSEMBLY
1. See Figure 2-108. Remove rubber boots (1) from rear of
headlight housing.
2. Disconnect wiring harness (5) from headlight bulbs (3)
and remove along with position bulb socket (6).
3. Remove bulb holders (2).
4. Remove headlight bulbs (3) from back of headlight hous-
ing (4).
b1226x2x
b1150x2x
1. Boot (2)
2. Bulb holder (2)
3. Bulb (2)
4. Headlight housing
5. Wiring harness
6. Position bulb socket
(used for HDI only)
7. Headlight connector
1
2
5
7
6
Figure 2-108. Headlight Assembly
ASSEMBLY
1. See Figure 2-108. Align and install headlight bulbs (3)
into back of headlight housing (4).
NOTE
The tab on the base of the headlight bulb should rest
between the two tabs located at the top of the hole on the
back of the headlight assembly.
2. Install bulb holders (2).
3. Connect wiring harness (5) to headlight bulbs (3) and
install rubber boots (1) and install position bulb socket (6)
between the headlights. For alignment of rubber boots,
see 7.12 HEADLIGHT.
3
4
2007 Buell Ulysses: Chassis 2-75