Rear Brake Master Cylinder - Buell 2007 ULYSSES Service Manual

HOME

REAR BRAKE MASTER CYLINDER

REMOVAL
1. See Figure 2-50. Drain brake fluid into a suitable con-
tainer. Discard used fluid according to local laws.
a. Install a length of plastic tubing over caliper bleeder
valve. Place free end in a suitable container.
b. Open bleeder valve (metric) about 1/2-turn.
c. Pump brake foot pedal to drain brake fluid.
d. Tighten bleeder valve to 36-60 in-lbs (4-7 Nm).
2. Remove right side footpeg mount. See
GUARD AND FOOTPEG
NOTE
Damaged banjo bolt seating surfaces will leak when reas-
sembled. Prevent damage to seating surfaces by carefully
removing brake line components.
3. See Figure 2-51. Remove brake reservoir hose (1) at
master cylinder.
4. Remove cotter pin from brake pedal. See
PEDAL.
5. Remove seat. See 2.45
6. See Figure 2-52. Disconnect brake light connector
located under the seat.
.
2-36 2007 Buell Ulysses: Chassis
2.34 HEEL
MOUNTS.
2.9 BRAKE
SEAT.
11125
Figure 2-50. Brake Bleeder Valve, Rear Caliper
11127
4
2
1. Reservoir hose
2. Cotter pin
3. Banjo bolt (metric)
4. Fasteners (2)
Figure 2-51. Rear Master Cylinder
2.13
3
1