Buell 2007 ULYSSES Service Manual page 636

HOME
11930
1. Turn signal flasher connector [30]
2. Instrument cluster connector [39]
3. Right handlebar connector [22]
4. Left handlebar connector [24]
5. Turn signal connectors [31]
6. Ignition switch
8. Install cable and harness guide at steering head.
9. See Figure 7-87. Connect:
Ignition switch [33].
Auxiliary power outlet [160].
Turn signal flasher connector [30].
Instrument module connector [39].
Left switch housing connector [24] and right switch
housing connector [22].
Turn signal connectors [31].
Headlight connector [38].
Horn connectors [122].
Clutch switch [95] from left switch housing.
Front brake switch [121] from right switch housing.
Active muffler [165].
O2 sensor [137].
Temp sensor [90]
Fuel injectors [84] & [85].
Ground fastener at steering head.
10. Connect fuel line at fuel rail.
11. Install cable strap loosely around main harness (6) and
ignition switch.
12. Connect throttle position sensor [88]. See
TLE POSITION SENSOR.
13. Connect intake air temperature sensor [89]. See
INTAKE AIR TEMPERATURE
3
6
5
12
Figure 7-87. Electrical Connectors Behind Windscreen
4.37 THROT-
4.36
SENSOR.
2
4
9
11
8
10
7. Cable strap
8. Main harness
9. Horn fastener
10. Horn mount
11. Horn connector [122]
12. Horn
14. Install connector on oil pressure switch [120]. See
OIL PRESSURE INDICATOR
15. Install and connect ignition coil. See
ASSEMBLY.
16. Install starter side of positive battery cable to starter.
17. Connect starter solenoid [128].
18. Install sprocket cover wiring. See
COVER WIRING.
19. Connect fan connector [97].
20. Install fan and tighten fasteners to 12-36 in-lbs (1.4-4.1
Nm). See 4.38 COOLING
21. Install rear shock absorber assembly. See
SHOCK ABSORBER.
22. Install intake cover. See
BLY.
2007 Buell Ulysses: Electrical
1
5
7
SWITCH.
4.44 AIR CLEANER
7.26 SPROCKET
FAN.
2.23 REAR
2.39 INTAKE COVER ASSEM-
3.12
7-73