Buell 2007 ULYSSES Service Manual page 637

HOME
11966b
8
7
1. Main harness
2. Battery ground cable
3. Battery positive cable
4. ECM connectors [10] [11] and [164]
23. Pull rear section of main harness up over trunk pan
towards the rear of the vehicle and place connectors in
general location of installation.
24. Install fuse block and relay center on support bracket.
25. See Figure 7-88. Connect:
Tail light connectors [93].
Left turn signal connector [19].
Right turn signal connector [18].
BAS (bank angle sensor) connector [134].
ECM connectors [10], [11] and [164].
Rear brake light switch connector [121].
Ground terminals on left side tail section.
License plate lamp connector [45].
Interactive exhaust subharness [165].
Rear auxiliary power outlet [180].
26. Route main harness and rear auxiliary power outlet wir-
ing under seat latch bracket.
27. Tighten fasteners.
28. Install main harness and grommet into battery tray.
29. Install rear wire cover.
30. Verify that front forks can be turned from full left to full
right lock without wire harness binding or pinching.
7-74 2007 Buell Ulysses: Electrical
2
5
Figure 7-88. Main Harness and Electrical Connectors Under Seat
4
5. Fuse block and relay center
6. BAS (bank angle sensor) connector [134]
7. Rear auxiliary outlet [180]
8. Center tail section
1 1
Connect positive (+) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00068a)
31. Install positive battery cable (red) to positive terminal of
battery. Tighten to 72-96 in-lbs (8-11 Nm).
32. Connect negative battery cable. Tighten to 72-96 in-lbs
(8-11 Nm).
33. Verify operation of all electrical components.
34. Install windshield and windscreen. See
SHIELD AND WINDSCREEN.
1 1
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
35. Install seat. See 2.45 SEAT.
1
6
WARNING WARNING
2.44 WIND-
WARNING WARNING