Configuring A Dual-Homed Pe With Redundant Ldp Pws; Configuring Mac Address Learning; Displaying And Maintaining Vpls - HP 10500 Series Configuration Manual

Configuring a dual-homed PE with redundant LDP PWs

Step
1. Enter system view.
2. Enter VSI view.
3. Configure the VSI to LDP to
establish PWs, and enter VSI
LDP view.
4. (Optional.) Specify whether to
switch traffic from the backup
PW to the primary PW when
the primary PW recovers, and
the wait time for the
switchover.
5. Configure a VPLS PW and
enter VSI LDP PW view.
6. Configure a backup VPLS PW
and enter VSI LDP backup PW
view.
7. Return to user view.
8. Manually switch traffic of the
specified PW to its backup
PW.

Configuring MAC address learning

Step
1. Enter system view.
2. Enter VSI view.
3. Enable MAC address
learning for the VSI.

Displaying and maintaining VPLS

Execute display commands in any view and the reset command in user view.
Task
Display LDP PW label information.
Display L2VPN forwarding information (in
standalone mode).
Command
system-view
vsi vsi-name
pwsignaling ldp
revertive { wtr wtr-time | never }
peer ip-address pw-id pw-id
[ no-split-horizon | pw-class class-name
| tunnel-policy tunnel-policy-name ] *
backup-peer ip-address pw-id pw-id
[ pw-class class-name | tunnel-policy
tunnel-policy-name ] *
return
l2vpn switchover peer ip-address pw-id
pw-id
Command
system-view
vsi vsi-name [ hub-spoke ]
mac-learning enable
Command
display l2vpn ldp [ peer ip-address [ pw-id pw-id ] | vsi
vsi-name ] [ verbose ]
display l2vpn forwarding { ac | pw } [ vsi vsi-name ] [ slot
slot-number ] [ verbose ]
273
Remarks
N/A
N/A
By default, no PW signaling
protocol is specified for the
VSI.
By default, when the primary
PW recovers, traffic is
immediately switched back
from the backup PW to the
primary PW.
By default, no VPLS PW is
configured.
By default, no backup VPLS
PW is configured.
N/A
N/A
Remarks
N/A
N/A
By default, MAC address learning is
enabled for a VSI.