Dell S2810dn User Manual page 66

4 Before loading the print media, flex the sheets and fan them. Straighten the edges of the stack on a level surface.
5 Load the print media into the tray with the recommended print side facing up.
NOTE:
Do not exceed the maximum fill line in the tray. Overfilling the tray may cause paper jams.
6 Align the width guides against the edges of the paper.
NOTE:
When loading user-specified print media, adjust the width guides and slide the extendable part of the tray by
pinching the length guide and sliding it until it rests lightly against the edge of the paper.
7 After confirming that the guides are securely adjusted, insert the tray into the printer.
NOTE:
If the front side of the tray is extended, the tray protrudes when it is inserted into the printer.
8 On the operator panel, press the
(Set) button.
9 Press the or
NOTE:
Set the same paper size and type as the actual paper being loaded. An error may occur if the paper size or type
setting is different from the loaded paper.
66
Loading Paper
or button until the desired paper size is highlighted, and then press the
button until the desired paper type is highlighted, and then press the (Set) button.