Download  Print this page

Usb Settings; System Settings - Dell S2810dn User Manual

Smart printer.
Hide thumbs

Advertisement

*
TBCP
Used when the communication protocol supports both ASCII and binary data to switch between them
according to the specified control code.
Binary
Used when no special processing is required for data.

USB Settings

Use the USB Settings menu to change printer settings affecting a USB port.
USB Port
Purpose:
To specify whether to enable the USB port. The change becomes effective after the printer is turned off and then on
again.
Values:
Disable
*
Enable
PS Data Format
Purpose:
To specify PostScript 3 Compatible communication protocol, you can configure the PS Data Format settings.
The change becomes effective after the printer is turned off and then on again.
Values:
Auto
Standard
BCP
*
TBCP
Binary
Job Time-out
Purpose:
To specify the amount of time the printer waits for data to arrive from the computer. The print job is canceled if the time-out
time is exceeded.
Values:
Off
*
*
On
30 seconds
Available Range:
5–300 seconds

System Settings

Use System Settings to configure the power saving mode, warning tones, time-out duration, display language,
and job log auto print settings.
NOTE:
Values marked by an asterisk (*) are the factory default menu settings.
Disables the USB interface.
Enables the USB interface.
Used when auto-detecting the PostScript 3 Compatible communication protocol.
Used when the communication protocol is in ASCII interface.
Used when the communication protocol is in binary format.
Used when the communication protocol supports both ASCII and binary data to switch
between them according to the specified control code.
Used when no special processing is required for data.
Disables the job time-out.
Sets the time the printer waits for data to arrive from the computer.
Understanding the Printer Menus
151

Advertisement

Table of Contents

   Also See for Dell S2810dn

   Related Manuals for Dell S2810dn

Comments to this Manuals

Symbols: 0
Latest comments: