Dell S2810dn User Manual page 148

WPS Setup
Push Button
Configuration
PIN Code
PIN Code
Print PIN Code
Reset PIN Code
Ethernet
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes effective after the
printer is turned off and then on again.
Values:
*
Auto
10BASE- T Half
10BASE- T Full
100BASE- TX Half
100BASE- TX Full
1000BASE- T Full
TCP/IP
Purpose:
To configure TCP/IP settings.
Values:
*
IP Mode Dual Stack
IPv4 Mode
IPv6 Mode
IPv4 Get IP Address
IP Address
148
Understanding the Printer Menus
Configures the Wi-Fi Direct network using WPS.
Configures the Wi-Fi Direct network with WPS-PBC.
Configures the Wi-Fi Direct network using PIN code assigned
automatically by the printer.
Displays the current PIN code only when WPS Setup is set to PIN Code.
Prints the PIN code. Confirm it when entering PIN assigned to the printer
into your Wi-Fi mobile device.
Resets the PIN code.
Detects the Ethernet settings automatically.
Uses 10BASE-T Half-duplex.
Uses 10BASE-T Full-duplex.
Uses 100BASE-TX Half-duplex.
Uses 100BASE-TX Full-duplex.
Uses 1000BASE-T Full-duplex.
Uses both IPv4 and IPv6 to set the IP address.
Uses IPv4 to set the IP address.
Uses IPv6 to set the IP address.
*
AutoIP Sets the IP address automatically. A random value in the range of
169.254.0.0 to 169.254.255.255 that is not currently in use on the
network is set as the IP address. The subnet mask is set as
255.255.0.0.
BOOTP Sets the IP address using BOOTP .
RARP Sets the IP address using RARP.
DHCP Sets the IP address using DHCP.
Panel Use this option when you want to set the IP address manually on
the operator panel.
When an IP address is being set manually, the IP is allocated to the
printer using the format nnn.nnn.nnn.nnn. Each octet that makes
up nnn.nnn.nnn.nnn is a value in the range of 0 to 255.