Installing An Enhanced Remote Kit; Installation - Tait TM8100 mobiles Service Manual

26

Installing an Enhanced Remote Kit

26.1

Installation

TM8100/TM8200 Service Manual
© Tait Electronics Limited November 2007
The control head of a graphical-display radio can be installed remotely from
the radio body. The diagram below shows the parts used for this installation.
control-head interface
remote U-bracket
TMAA03-03 remote
control-head back
(includes remote U-bracket)
Note
Although the torso interface is similar in appearance to the RJ45
control head on the telemetry radio, the control head on the
telemetry radio cannot be used for remote installation.
Warning!!
Mount the remote U-bracket with the remote
control-head assembly and the U-bracket with
the radio body securely. These units must not
break loose in the event of a collision. Unse-
cured radio units are dangerous to the
vehicle occupants.
Caution
Observe the installation warnings and safety regula-
tions in the installation procedures of the radio.
Important
This equipment contains devices which are susceptible to
damage from static discharges. Refer to
on page 112
Note
Torx T10 and T20 screwdrivers are required for most of the screws
in this installation.
The circled numbers in the following sections refer to the items in
on page 546.
TMAA04-01 remote cable
for more information.

Installing an Enhanced Remote Kit

TMAC34-0T (TM8200) or
TMAC34-1T(TM9100)
torso interface
"ESD Precautions"
Figure 26.1
545