Installing An Optional Cd/Dvd Drive - IBM System x3750 M4 Type 8722 Installation And Service Manual

d. Rotate the drive tray handle to the closed position and slide the release
latch up to secure the drive tray handle in place.
e. Replace the filler panel (EMC filler panel).
5. Check the drive status LED to verify that the drive is operating correctly. If the
amber drive status LED for a drive is lit continuously, that drive is faulty and
must be replaced. If the green drive activity LED is flashing, the drive is being
accessed.
Note: If the server is configured for RAID operation through a ServeRAID
adapter, you might have to reconfigure your disk arrays after you install drives.
See the ServeRAID adapter documentation for additional information about
RAID operation and complete instructions for using the ServeRAID adapter.
6. If you are installing additional hot-swap drives, do so now.
7. Complete the additional steps in "Instructions for IBM Business Partners" on
page 24.

Installing an optional CD/DVD drive

To install an optional CD/DVD drive, complete the following steps:
1. Read the safety information that begins on page "Safety" on page vii and
"Installation guidelines" on page 33.
2. Turn off the server (see "Turning off the server" on page 21) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables from the server.
3. Remove the top cover (see "Removing the server top cover" on page 36).
4. Locate the blue release tab on the rear of the CD/DVD drive bay; then, while
you press the tab, push the CD/DVD filler toward the front of the server.
5. Pull the CD/DVD drive filler out of the front of the server.
6. Touch the static-protective package that contains the new optical drive to any
unpainted metal surface on the server; then, remove the optical drive from the
package and place it on a static-protective surface.
7. Remove the retention clip from the side of the drive filler.
CD/DVD-ROM
drive
Chapter 2. Installing optional devices
63