Pcie Riser Card; Installation Guidelines - IBM System x3750 M4 Type 8722 Installation And Service Manual

Microprocessor 3
error LED

PCIe riser card

The following illustration shows the connectors and LEDs on the optional PCIe
riser card:
PCI slot 1

Installation guidelines

Attention: Static electricity that is released to internal server components when
the server is powered on might cause the system to halt, which might result in the
loss of data. To avoid this potential problem, use an electrostatic-discharge wrist
strap and plug it into the Electrostatic-discharge connector on the front of the
server (near the video connector) or other grounding system when you remove or
install a hot-swap device.
Before you install optional devices, read the following information:
v Read the safety information that begins on page "Safety" on page vii and the
v Make sure that the devices that you are installing are supported. For a list of
DIMMs
31-42
error LEDs
DIMMs
25-30
error LEDs
PCI slot 2
error LED
PCI slot 1
error LED
PCI slot 3
PCI slot 2
guidelines in "Handling static-sensitive devices" on page 35. This information
will help you work safely.
supported optional devices for the server see http://www.ibm.com/systems/
info/x86servers/serverproven/compat/us/.
Microprocessor 4
error LED
PCI slot 3
error LED
Chapter 2. Installing optional devices
DIMMs
43-48
error LEDs
33