Replacing A Microprocessor And Heat Sink - IBM System x3750 M4 Type 8722 Installation And Service Manual

13. Place the microprocessor on a static-protective surface. Remove the
14. If you are instructed to return the microprocessor, follow all packaging

Replacing a microprocessor and heat sink

To replace an additional microprocessor and heat sink, complete the following
steps:
Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details about handling these devices, see
"Handling static-sensitive devices" on page 35.
Note:
v This procedure for replacing a microprocessor and heat sink also apply when
v See "Installing an additional microprocessor and heat sink" on page 89 for notes
v Use the microprocessor installation tool that came with the new microprocessor
v Be extremely careful when handling the microprocessor, the microprocessor
v The server supports up to four Intel Xeon dual-core or quad-core
274
System x3750 M4 Types 8722 and 8733: Installation and Service Guide
b. Align the holes on the installation tool with the screws on the
microprocessor bracket, then lower the microprocessor installation tool
down over the microprocessor. The installation tool rests flush on the
socket only if it is aligned correctly.
c. Twist the handle on the installation tool clockwise and lift the
microprocessor out of the socket.
microprocessor from the installation tool by twisting the handle
counterclockwise.
instructions, and use any packaging materials for shipping that are supplied
to you. Do not return the microprocessor installation tool.
replacing a microprocessor and heat sink on the microprocessor and memory
expansion tray.
and other information that you must consider when you install a
microprocessor.
kit to remove the microprocessor from the server.
socket contacts are very fragile.
microprocessors (two on the base system board and two on the optional