Recovering The Server Firmware (Uefi Update Failure) - IBM System x3750 M4 Type 8722 Installation And Service Manual

Recovering the server firmware (UEFI update failure)

Important: Some cluster solutions require specific code levels or coordinated code
updates. If the device is part of a cluster solution, verify that the latest level of
code is supported for the cluster solution before you update the code.
If the server firmware has become corrupted, such as from a power failure during
an update, you can recover the server firmware in either of two ways:
v In-band method: Recover the server firmware, using either the UEFI boot
v Out-of-band method: Use the IMM web interface to update the firmware, using
Note: You can obtain a server update package from one of the following sources:
v Download the server firmware update from the World Wide Web.
v Contact your IBM service representative.
To download the server firmware update package from the World Wide Web, go to
http://www.ibm.com/supportportal/.
The flash memory of the server consists of a primary bank and a backup bank. You
must maintain a bootable UEFI firmware image in the backup bank. If the server
firmware in the primary bank becomes corrupted, you can either manually boot
the backup bank with the UEFI boot recovery jumper (J71), or in the case of image
corruption, this will occur automatically with the Automated Boot Recovery
function.
In-band manual recovery method
To recover the server firmware and restore the server operation to the primary
bank, complete the following steps:
recovery jumper (Automated Boot Recovery) and a server Firmware Update
Package Service Pack.
the latest server firmware update package.
1. Turn off the server, and disconnect all power cords and external cables.
2. Remove the server cover. See "Removing the server top cover" on page 206
for more information.
3. Locate the UEFI boot recovery jumper (J71) on the system board.
Chapter 4. Troubleshooting
191