Removing The Operator Information Panel Assembly - IBM System x3750 M4 Type 8722 Installation And Service Manual

Removing the operator information panel assembly

To remove the operator information panel, complete the following steps.
1. Read the safety information that begins on page "Safety" on page vii and
2. Turn off the server (see "Turning off the server" on page 21) and all attached
3. Slide the server out of the rack.
4. Remove the server cover (see "Removing the server top cover" on page 206).
5. Disconnect the cable from the rear of the operator information panel assembly.
6. Lift the two release tabs on the rear of the operator information panel and
7. If you are instructed to return the operator information panel assembly, follow
260
System x3750 M4 Types 8722 and 8733: Installation and Service Guide
"Installation guidelines" on page 33.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
carefully slide the assembly out of the front of the server.
Operator information
panel
all packaging instructions, and use any packaging materials for shipping that
are supplied to you.
Tabs