Replacing A Raid Cache Card - IBM System x3750 M4 Type 8722 Installation And Service Manual

Replacing a RAID cache card

Note: For additional information and notes about installing adapters, see
"Installing an adapter" on page 66.
To replace an RAID cache card, complete the following steps:
1. Read the safety information that begins on page "Safety" on page vii and
2. Touch the static-protective package that contains the new RAID cache card to
3. If you are replacing a cache card that is installed on the system board,
4. If you are replacing a cache card on the RAID adapter, complete the following
252
System x3750 M4 Types 8722 and 8733: Installation and Service Guide
"Installation guidelines" on page 33.
any unpainted surface on the outside of the server; then, grasp the card by the
top edge or upper corners of the card and remove it from the package.
complete the following steps.
a. Connect the battery cable or flash power module cable to the cache card.
b. Align the cache card with the RAID cache card slot on the system board
and lower it onto the connector.
c. Gently press down on the center of the cache card until it is firmly seated
into the connector.
d. Reconnect the cache card cable to the battery or flash power module in the
battery/flash power module tray.
e. Continue to step 5 on page 253.
steps:
a. Align the cache card with the RAID cache card slot on the RAID adapter
and lower it onto the connector.
RAID cache card
Release
tab
RAID cache
card connector