IBM System x3750 M4 Type 8722 Installation And Service Manual page 318

Hide thumbs Also See for System x3750 M4 Type 8722:
Table of Contents

Advertisement

I.2018002 • I.3048005
I.2018002
[I.2018002] The device found at Bus % Device % Function % could not be configured due to
resource constraints. The Vendor ID for the device is % and the Device ID is %.
Explanation: OUT_OF_RESOURCES (PCI Option ROM)
Severity: Info
User response: Complete the following steps:
1.
If this PCIe device or any attached cables were installed, moved, serviced or upgraded recently, reseat the
adapter and any attached cables.
2.
Check the IBM support site for any service bulletin or firmware updates that apply to this error. It might be
necessary to disable unused option ROMs from the UEFI F1 Setup, from the ASU, or by using the adapter
manufacturer utilities so that adapter firmware can be updated.
3.
Move the adapter to a different slot. If a slot is not available or error recurs, replace the adapter.
4.
If adapter was moved to a different slot and error did not recur, verify that this is not a system limitation. Then
replace the system board. Also, if this is not the initial installation and the error persists after adapter
replacement, replace the system board.
I.2018003
[I.2018003] A bad option ROM checksum was detected for the device found at Bus % Device %
Function %. The Vendor ID for the device is % and the Device ID is %.
Explanation: ROM CHECKSUM ERROR
Severity: Info
User response: Complete the following steps:
1.
If this PCIe device or any attached cables were installed, moved, serviced or upgraded recently, reseat the
adapter and any attached cables.
2.
Move the adapter to a different system slot, if a slot is available.
3.
Check the IBM support site for any service bulletins or firmware updates that apply to this error. It might be
necessary to configure slot to Gen1 or to use special utility software so that adapter firmware can be upgraded.
Gen1/Gen2 settings can be configured via F1 Setup -> System Settings -> Devices and I/O Ports -> PCIe
Gen1/Gen2/Gen3 Speed Selection, or the ASU Utility.
4.
Replace the adapter.
I.3048005
[I.3048005] UEFI has booted from the backup flash bank.
Explanation: Booting Backup UEFI Image
Severity: Info
User response: Refer to the section on recovering a UEFI image from an update failure for instructions on how to
restore the system to the primary bank.
302
System x3750 M4 Types 8722 and 8733: Installation and Service Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

System x3750 m4 type 8733

Table of Contents