Removing The Cd/Dvd Cable - IBM System x3750 M4 Type 8722 Installation And Service Manual

5. Reconnect the power cord and any cables that you removed.
6. Replace the server cover and slide the serve back into the rack.
7. Turn on the peripheral devices and the server.

Removing the CD/DVD cable

To remove the CD/DVD cable, complete the following steps:
1. Read the safety information that begins on page "Safety" on page vii and
2. Turn off the server (see "Turning off the server" on page 21) and all attached
3. Remove the top cover (see "Removing the server top cover" on page 206).
4. Remove the fan cage assembly (see "Removing the fan cage assembly" on page
5. Slide the CD/DVD out of the server (see "Removing a CD/DVD drive" on
6. Facing the front of the server, grasp the cable connector latch (right of the cable
7. Disconnect the other end of the cable from the optical drive connector on the
220
System x3750 M4 Types 8722 and 8733: Installation and Service Guide
CD/DVD-ROM
drive
"Installation guidelines" on page 33.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
245).
page 217).
connector) and pull it up toward the rear of the server; then, slide the cable
connector to the left to disconnect it from the optical drive connector on the
rear of the optical drive cage.
system board.