Config.ip.ethernet; Config.ip.show - McDATA OPENconnectors Command Line Interace Command Line Interface Manual

CLI Commands
2
2-6 McDATA OPENconnectors Command Line Interface USER MANUAL
ethernet ipAddress gatewayAddress subnetMask
This command sets the Ethernet network settings.
The Telnet connection can be lost when these Ethernet network settings are
changed.
If the IP address is reconfigured, your Telnet client must be reconnected to
the new IP address. A new login will be requested.
This command has three parameters.
ipAddress Specifies the new IP address for the director or
switch. The address must be entered in dotted
decimal format (for example, 10.0.0.0).
gatewayAddress Specifies the new gateway address for the
Ethernet interface. The address must be entered
in dotted decimal format (for example, 0.0.0.0).
subnetMask Specifies the new subnet mask for the Ethernet
interface. The address must be entered in dotted
decimal format (for example, 255.0.0.0).
Root> config ip ethernet 10.0.0.0 0.0.0.0 255.0.0.0
show
This command shows the LAN configuration.
This command has no parameters.
Root> config ip show
P/N 620-000134-300