McDATA OPENconnectors Command Line Interace Command Line Interface Manual page 19

The command tree of the CLI begins from the root. The commands in
the four extended branches (config, maint, perf, and show) are
described in
There are three additional commands (login, logout, and
commaDelim) that are globally available commands. These
commands are described in this chapter.
The hierarchy from the root, reading from left to right, is as follows.
CLI Command Tree
Table 1-2
config -------------------- features ----------------- installKey
Chapter 2, CLI Commands.
enterpriseFabMode
ficonms
OpenSysMS
show
ip-------------------------- ethernet
show
port ----------------------- blocked
extDist
fan
name
speed
type
show
security ----------------- fabricBinding ----------- activatePending
portBinding ------------- bound
switchBinding ---------- addMember
Entering Command Line Interface Commands
Introduction
addMember
clearMemList
deleteMember
replacePending
setFabBindState
showActive
showPending
wwn
show
deleteMember
setSwitchBindState
1-5
1