Config.zoning.activatezoneset - McDATA OPENconnectors Command Line Interace Command Line Interface Manual

CLI Commands
2
activateZoneSet
This command activates the zone set contained in the work area to
the fabric and takes effect immediately.
This command takes effect immediately in the fabric.
This command has no parameters.
Root> config zoning activateZoneSet
If the interoperability mode for the switch or director is set to Open Fabric 1.0
mode when the zone is activated, any zone members specified by port
number are ignored.
deactivateZoneSet
This command places all attached devices in the default zone and
takes effect immediately fabric wide.
The default zone must be activated independently of this command.
This command takes effect immediately in the fabric.
This command has no parameters.
Root> config zoning deactiveZoneSet
config 2-45