connectionless
connector
control processor
card
control unit
CRC
CTP
cyclic redundancy
check
D
datagram
default
default zone
device
P/N 620-000134-500
configuration. A configuration backup file is required to restore
configuration data if the CTP card in a nonredundant Intrepid 6064 is
removed and replaced.
Nondedicated link. Typically used to describe a link between nodes
which allows the switch to forward Class 2 or Class 3 frames as
resources (ports) allow. Contrast this to the dedicated bandwidth that
is required in a Class 1 Fibre Channel Service point-to-point link.
See optical fiber connector.
Circuit card that contains the director microprocessor. The CTP card
also initializes hardware components of the system after power-on. A
10 Mbps RJ-45 twisted pair connector is located on the CTP card to
connect to the Ethernet LAN and communicate with the EFC Server
or a specific management station.
A hardware unit that controls the reading, writing, or displaying of
data at one or more input/output units.
See cyclic redundancy check.
See control processor card.
System of error checking performed at both the sending and
receiving station using the value of a particular character generated
by a cyclic algorithm. When the values generated at each station are
identical, data integrity is confirmed.
See Class 3 Fibre Channel service.
Pertaining to an attribute, value, or option that is assumed when none
is explicitly specified.
Contains all attached devices that are not members of a separate
zone.
Product, connected to a managed director, connected to a switch or
director, that is not controlled by the switch or director's management
software. See also node.
McDATA OPENconnectors Command Line Interface USER MANUAL
Glossary
g-3