McDATA OPENconnectors Command Line Interace Command Line Interface Manual page 48

CLI Commands
2
config.security.fabricBinding.clearMemList
config.security.fabricBinding.deleteMember
2-16 McDATA OPENconnectors Command Line Interface USER MANUAL
clearMemList
This command clears the fabric membership list for the pending
fabric binding working area.
This information is not saved to the fabric until the activatePending
command is issued. When the list is cleared, the CLI automatically adds the
managed switch to the fabric membership list.
This command has no parameters.
deleteMember wwn domainId
This command removes a member from the Fabric Member List in
the pending fabric binding work area.
Changes are not activated to the fabric until the activatePending command is
issued.
This command has two parameters:
wwn Specifies the WWN of the member to be
removed from the fabric membership list. The
value of the WWN must be in colon-delimited
hexadecimal notation (for example,
AA:00:AA:00:AA:00:AA:00).
domainId The domain ID of the member to be removed
from the fabric membership list. Valid domain
ID's range from 1 to 31.
Root> config security fabricBinding deleteMember
AA:99:23:23:08:14:88:C1
Root> config security fabricBinding deleteMember 2
P/N 620-000134-300