Show.port.nodes - McDATA OPENconnectors Command Line Interace Command Line Interface Manual

nodes portNumber
This command displays the loop node list for a specified port. This
command is valid only on the Sphereon 4500.
This command has one parameter.
portNumber Specifies the port number. Valid values are:
0–23 for the Sphereon 4500
Root> show port nodes portNumber
The port nodes data is displayed as a table that includes the following
properties.
FC Addr The Fibre Channel address of nodes attached to
this port. Private devices are assigned address
strings of 0000 followed by the two-digit
hexadecimal Arbitrated Loop Physical Address
(ALPA), instead of the 6 digit hexadecimal
number presented for public devices.
Attached WWN The WWN of nodes attached to this port, or the
string NOT LOGGED IN for a private loop
device.
Class The Class value for public devices. This field is
left blank for private devices.
Data Field Size The Data Field Size value for public devices.
This field is left blank for private devices.
CLI Commands
2
show 2-77