Config.snmp.show - McDATA OPENconnectors Command Line Interace Command Line Interface Manual

Mcdata openconnectors command line interace user manual
Table of Contents

Advertisement

show
This command shows the switch SNMP configuration.
This command has no parameters.
Root> config snmp show
The switch configuration data is displayed as a table that includes the
following properties.
Authorization
The state of the authorization traps (for
Traps
example, enabled) that are sent to SNMP
management stations when unauthorized
stations attempt to access SNMP information
from the switch.
Index
The community index number.
Community Name
The name of the community.
WriteAuth
The write authorization state.
Trap Recipient
The address of the trap recipient.
UDP Port
The user datagram protocol (UDP) port number
to which the director will send traps for each
recipient.
The output from the config.snmp.show command displays as
follows.
Authorization Traps: Enabled
Index Community Name
----- -------------------------------- --------- --------------- --------
1
CommunityName1
2
CommunityName2
3
CommunityName3
4
public
5
6
WriteAuth Trap Recipient
Enabled
123.123.123.123 162
Enabled
10.25.25.10
Disabled
132.44.85.224
Enabled
CLI Commands
2
UDP Port
144
162
162
config
2-31

Advertisement

Table of Contents
loading

This manual is also suitable for:

Openconnectors

Table of Contents