Config.zoning.addportmem - McDATA OPENconnectors Command Line Interace Command Line Interface Manual

addPortMem "zoneName" domainId portNumber
This command adds the domain ID and port number of a zone
member to the specified zone in the work area.
Port numbers cannot be used for zone members if the interoperability mode
for the switch or director is set to Open Fabric 1.0 mode.
The CLI supports the number of zones members per zone specified
for a given product.
This command has one parameter.
zoneName Specifies the name of the zone.
domainId Specifies the domain ID of the member to be
added to the zone. Valid values are in the range
1–31.
Specifies the port number of the member to be
portNumber
added to the zone. Valid port number values are:
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–31 for the ED-5000
0–63 for the Intrepid 6064
0–127 and 132–144 for the Intrepid 6140
Root> config zoning addPortMem TheUltimateZone 10 6
CLI Commands
2
config 2-49