Show.ip.ethernet - McDATA OPENconnectors Command Line Interace Command Line Interface Manual

CLI Commands
2
2-70 McDATA OPENconnectors Command Line Interface USER MANUAL
The output from the show.frus command displays as follows.
FRU Position State
----- -------- ------
CTP 0 Active
CTP 1 Backup
SBAR 0 Active
SBAR 1 Failed
FPM 1 Active
FPM 3 Active
UPM 4 Active
Power 0 Active
Fan 0 Active
ethernet
This command displays ethernet attributes.
This command has no parameters.
Root> show ip ethernet
The Ethernet attributes data is displayed as a table that includes the
following properties.
IP Address The IP address for the Ethernet adapter as set in
the config.ip.ethernet command.
Gateway The gateway address for the Ethernet adapter
Address as set in the config.ip.ethernet command.
Subnet Mask The subnet mask for the Ethernet adapter as set
in the config.ip.ethernet command.
The output from the show.ip.ethernet command displays as follows.
LAN Information
IP Address:
Gateway Address:
Subnet Mask:
Serial Num Part Num
-------------- ---------
470-000399-700 123456789
470-000399-700 223456789
470-000399-700 223456789
470-000399-700 223456789
470-000399-700 223456789
470-000399-700 223456789
470-000399-700 223456789
470-000399-700 223456789
470-000399-700 223456789
144.49.10.15
144.49.10.1
255.255.255.0
Beacon Pwr On Hrs
--------- ----------
Off 2800
On 2801
Off 2801
Off 2801
Off 2801
Off 831
Off 831
Off 831
Off 831
P/N 620-000134-300