Table of Contents
Advertisement
priority switchPriority
This command sets the switch priority.
The switch must be set offline before this command is entered.
This command has one parameter.
switchPriority
Specifies the switch priority. Valid values are:
principal, default, or neverprincipal.
principal — sets the numerical switch priority
to 1. The switch with a priority of 1 becomes the
principal switch; however, if two or more
switches have a priority of 1, the switch with
the lowest WWN becomes the principal switch.
default — sets the numerical switch priority
to 254. If no switch is set to principal, the switch
with a priority 254 becomes the principal
switch; however, if two or more switches have a
priority of 254, the switch with the lowest
WWN becomes the principal switch.
neverprincipal — sets the numerical switch
priority to 255. This switch is not able to become
the principal switch.
At least one switch in a multiswitch fabric must
have a switch priority value of principal or
default.
The number codes 2–253 are not now in use.
Root> config switch priority principal
CLI Commands
2
config
2-35
Advertisement
Table of Contents
