Config.port.fan - McDATA OPENconnectors Command Line Interace Command Line Interface Manual

fan portNumber fanOn
This command sets the fabric address notification (FAN) state for a
port (Sphereon 4500 only). This configuration can be applied to any
port regardless of its current configuration. The FAN value is applied
at the time the port is configured and operated in a loop.
This command has two required parameters.
portNumber Specifies the port number. Valid values are:
0–23 for the Sphereon 4500
fanOn Specifies the FAN state for the port. Valid values
are true and false. Boolean 1 and 0 may be
substituted as values.
Root> config port fan 4 1
CLI Commands
2
config 2-9