Maint.system.resetconfig; Maint.system.setonlinestate - McDATA OPENconnectors Command Line Interace Command Line Interface Manual

CLI Commands
2
2-58 McDATA OPENconnectors Command Line Interface USER MANUAL
resetConfig
This command resets all NV-RAM configuration parameters to their
default values, including feature keys and IP addresses.
This command IPLs the switch. Connection from the CLI to the
switch is lost when this command runs.
This command resets all configuration data and non-volatile settings,
including network information, to their default values (factory settings).
Management access may be lost until the network information is restored.
The default values are set in the firmware of the director or switch.
For information about the default values, refer to the service manual
for your director or switch.
This command has no parameters.
Root> maint system resetConfig
setOnlineState onlineState
This command sets the switch online or offline.
This command has one parameter.
onlineState Specifies whether the switch is online. Valid
values are true and false. Boolean 1 and 0 may be
substituted as values.
Root> maint system setOnlineState true
Root> maint system setOnlineState 1
P/N 620-000134-300