Show.ip.ethernet; Show.linkincidentlog - McDATA Enterprise Operating System User Manual

show
2
Output Example
FRU Position
----- --------
CTP 0
CTP 1
SBAR 0
SBAR 1
FPM 1
FPM 3
UPM 4
Power 0
Fan 0

show.ip.ethernet

Command Example
Output Example

show.linkIncidentLog

Enterprise Operating System Command Line Interface User Manual
2-154
The output from the show.frus command displays as follows.
State Serial Num
------ --------------
Active 470-000399-700
Backup 470-000399-700
Active 470-000399-700
Failed 470-000399-700
Active 470-000399-700
Active 470-000399-700
Active 470-000399-700
Active 470-000399-700
Active 470-000399-700
Syntax
ethernet
Purpose This command displays ethernet attributes.
Parameters This command has no parameters.
Root> show ip ethernet
Output The Ethernet attributes data is displayed as a table that includes the
following properties.
IP Address
Gateway
Address
Subnet Mask
The output from the show.ip.ethernet command displays as follows.
LAN Information
IP Address:
Gateway Address:
Subnet Mask:
Syntax
linkIncidentLog [clear]
Part Num Beacon
--------- ---------
123456789 Off
223456789 On
223456789 Off
223456789 Off
223456789 Off
223456789 Off
223456789 Off
223456789 Off
223456789 Off
The IP address for the Ethernet adapter as set in
the config.ip.ethernet command.
The gateway address for the Ethernet adapter
as set in the config.ip.ethernet command.
The subnet mask for the Ethernet adapter as set
in the config.ip.ethernet command.
144.49.10.15
144.49.10.1
255.255.255.0
Pwr On Hrs
----------
2800
2801
2801
2801
2801
831
831
831
831