Types of
Power Save
Mode
Power Save
2
Mode 2 (the
Printer Power
Save mode)
Power saving
effect: Middle
Power Save
Mode 3 (the
Deep Sleep
mode)
Power saving
effect: Large
* If [Server Name] for SMB is not specified, the printer can enter Power Save Mode regardless of the setting for SMB
SERVER.
NOTE
When the printer enters Power Save Mode 1 or 2, the Ready indicator and Main Power
•
indicator come on. However, when the printer is in the following statuses, indicators other
than the Ready indicator also come on.
- When the printer is offline (Only the Message indicator comes on.)
- While a job is being stored in a box* (The Job indicator comes on.)
When the printer enters Power Save Mode 3, only the Main Power indicator comes on.
•
To configure the printer so that it does not enter Power Save Mode when an error is
•
occurring in the printer (when the Message indicator is on, or when the number in the
message is blinking), set PWR SAVE IN ERR to OFF.
2-8
Turning the Printer ON/OFF
Settings for "POWER SAVE MODE"
Which Can be Entered
PANEL
OFF
OFF
-
-
* A job can be stored in a box only when a hard disk is installed.
DEEP
ON
SLEEP
-
-
-
Entering Conditions
- The printer has already
entered Power Save Mode 1.
- The 10 minutes for which the
printer is ready to print has
elapsed since the printer was
turned ON or Power Save
Mode 2 was released.
- There is no job on the print
queue.
- A service call is not
occurring.
- A paper jam is not occurring.
- No cover is open.
- The toner cartridge is
installed.
- The printer has already
entered Power Save Mode 2.
- The following settings in
NETWORK MENU are set to
OFF.
- APPLETALK
- SMB SERVER* in SMB
- A USB cable is not
connected.
- The 15 minutes for which the
printer is ready to print has
elapsed since the printer was
turned ON or Power Save
Mode 2 was released.