Netware Setting - Canon Laser Shot LBP5970 User Manual

■ NETWARE SETTING

5
■ APPLETALK
■ SMB
5-62 SETUP Menu Settings
IMPORTANT
After changing the settings for this item, cycle the power of the printer or perform a
hard reset to make the settings effective.
NOTE
This item is displayed only when all the following conditions are fulfilled.
- NETWORK in the I/F CONNECTION options is set to ON.
- [Primary Network Setting] is set to [Standard Network].
Specify the setting for [Primary Network Setting] in the [Extension Card] page in
the Remote UI or in EXTENSION CARD (See p. 5-66) in the control panel.
NETWARE ........................... OFF*, ON
FRAME TYPE ...................... AUTO DETECT*, ETHERNET 2, ETHERNET 802.2,
PRINT SERVICE.................. NDS PSERVER*, NPRINTER,
Configures the NetWare network settings.
NOTE
For more details on NetWare, see "Chapter 4 Using the Printer on a NetWare
Network (Windows)" in Network Guide.
OFF*, ON
Specifies whether the printer should use AppleTalk.
NOTE
For more details on AppleTalk, see "Chapter 6 Using the Printer on an AppleTalk
•
Network (Macintosh)" in Network Guide.
This item is displayed only when NETWORK in the I/F CONNECTION options is
•
set to ON.
SMB SERVER...................... OFF*, ON
1
SMB* .................................. OFF*, ON
*1 SMB is displayed only when an optional hard disk is installed, HARD DISK is set to ON, and SMB
SERVER is set to ON.
Specifies whether the printer should use the SMB protocol.
NOTE
This item is displayed only when NETWORK in the I/F CONNECTION options is
set to ON.
ETHERNET 802.3, ETHERNET SNAP
BINDERYPSERVER, RPRINTER